Eppendorf epMotion 96 - Manual (Page 42)

Operation
epMotion
® 96
English (EN)
42
6.9.2 Dispensing liquid
Prerequisites
• Liquid has been aspirated.
• Destination vessels are available.
1. Put the destination vessel onto the lifting table and move the lifting table into working position.
2. Press Dispense .
3. Change or reposition the destination vessel.
6.9.3 Semiautomatically dispensing liquid
It is advisable to use the Auto function when filling a single 384-well plate or several 96-well plates in
succession.
1. Press the Auto button.
2. Set the dispensing volume.
3. Set the number of steps for dispensing.
4. Aspirate liquid from a source vessel
5. Put the destination vessel onto the lifting table.
6. Move the lifting table into working position and tighten the locking handle.
7. Tighten the locking handle for the stop.
8. Move the lifting table into basic position.
9. Change or reposition the destination vessel.
10. Move the lifting table against the stop and keep it in this position until the dispensing of the liquid is
initiated.
The number of the remaining dispensing steps is displayed.