Snorkel Bi-Energy-sn1879-4274 - Manual (Page 2)

2
NEVER operate the machine without first surveying the work area for surface hazards such as
holes, drop-offs, bumps and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasten-
ers properly torqued.
SECURE and lock gate after mounting platform.
KEEP all body parts clear of outriggers when extending or retracting (outrigger equipped machines
only).
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
MAINTAIN tire pressure at 3.4 bars (50 psi). Check daily.
LOOK up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on
back cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged
control cable, loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assem-
bly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly
explosive hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and
removing key.
NEVER replace any component or part with anything other than original UpRight replacement parts
without the manufacturer's consent.
English Language Section
SAFETY RULES
NEVER operate the machine
within 3 m (10 ft) of power
lines. THIS MACHINE IS NOT
INSULATED. NEVER elevate or drive elevated
on uneven slopes or soft ground
or elevate the platform unless the
platform is level. NEVER sit, stand or climb
on guardrail or midrail.
47