32 technical support, 33 general procedure, 34 troubleshooting procedures – Snorkel LX41 Electric-sn4022+ User Manual
Page 72: 35 adjustment procedures, 36 checking pump pressures, 2 technical support -2, 3 general procedure -2, 4 troubleshooting procedures -2, 5 adjustment procedures -2, 6 checking pump pressures -2
Technical Support
Section 3 - Troubleshooting
Page 3-2
067448-003 LX31/LX41 Electric Work Platform
3-2 T
ECHNICAL
S
UPPORT
Technical Support is available by telephone of FAX.
U
U
U
U
P
P
P
P
R
R
R
R
IIIIG
G
G
G H
H
H
H T
T
T
T
USA
USA
USA
USA
Tel: 1-800-926-5438
FAX: 1-559-662-4785
U
U
U
U
P
P
P
P
R
R
R
R
IIIIG
G
G
G H
H
H
H T
T
T
T
E
E
E
E
U
U
U
U R
R
R
R O
O
O
O P
P
P
P E
E
E
E
Tel: +353-1-620-9300
FAX: +353-1-620-9301
3-3 G
ENERAL
P
ROCEDURE
Thoroughly study hydraulic and electronic schematics in the Schematics section. Check for loose con-
nections and short circuits. Check/repair/replace each component in the Truth Table which is listed under
each machine function which does not operate properly.
Determine whether the problem is mechanical (interference), electrical or hydraulic. Some functions
require power at more than one solenoid.
Use the charts on the following pages to help determine the cause of a fault in your UpRight work platform
NOTE:
Spike protection diodes at components have been left out of the charts to eliminate confusion.
3-4 T
ROUBLESHOOTING
P
ROCEDURES
1. Verify your problem.
• Do a full function test from both platform controls and chassis controls and note all functions that
are not operating correctly.
2. Narrow the possible causes of the malfunction.
• Use the troubleshooting guide to determine which components are common to all circuits that are
not functioning correctly.
3. Identify the problem component.
• Test components that are common to all circuits that are not functioning correctly. Remember to
check wires and terminals between suspect components. Be sure to check connections to battery
negative.
4. Repair or replace component found to be faulty.
5. Verify that repair is complete.
• Do a full function test from both platform and chassis controls to verify that all functions are oper-
ating correctly and machine is performing to specified values
3-5 A
DJUSTMENT
P
ROCEDURES
• Hydraulic settings must be checked whenever a component is repaired or replaced.
• Connect a pressure meter of appropriate range to the test port located on the hydraulic manifold.
• Correct pressure settings are listed in the hydraulic schematic.
3-6 C
HECKING
P
UMP
P
RESSURES
• Remove hose from pump port, and connect pressure tester.