Snorkel LX41 Electric-sn4022+ - Manual (Page 14)

Page 10 067449-002 LX Electric Work Platform - Operator Manual
Transporting the Work Platform
T RANSPORTING THE W ORK P LATFORM
P R E P A R A T I O N F O R S H I P M E N T
1. Fully lower the platform.
2. Disconnect the battery negative (–) lead from the battery terminal.
3. Band the controller to the front guardrail.
4. Band the elevating linkage to the frame.
Figure 7: Transporting Work Platform
L I F T I N G B Y C R A N E
1. Secure straps to chassis tie down/lifting
lugs only.
2. Place the platform onto the transport vehi-
cle in transport position.
3. Chock the wheels.
4. Secure the machine to the transport vehicle
with chains or straps of adequate load
capacity attached to the chassis tie
down/lifting lugs.
D R I V I N G O R W I N C H I N G O N T O A T R U C K O R T R A I L E R
NOTE: Do not winch faster than 0,3 m/s (1 ft/s) .
1. Move the machine onto the truck or trailer;
A. To Drive the machine onto the transport vehicle:
a. Move the machine up the ramp and into transport position.
b. Set the wheels straight and turn off the machine.
c. Chock the wheels.
B. To Winch the machine onto the transport vehicle:
a. Move the machine up to the ramp.
b. Attach the winch cable to the tie down/lifting lugs.
c. Release the parking brakes (refer to “Towing or Winching” on page 8).
d. Winch the platform into transport position
e. Chock the wheels.
2. Secure the machine to the transport vehicle with chains or straps of adequate load capacity attached to
the chassis tie down/lifting lugs.
C A U T I O N
Overtightening of chains or straps through tie down/lifting lugs may result in damage to the machine.
Front View Rear View
Tie-Down / Lifting Lugs