MBW CG200 - Manual (Page 44)

42
CHANGING HYDRAULIC OIL FILTERS:
1. Hydraulic oil filters are located underĆ
neath the main unit hopper and
slightly below the front of the oil tank.
2. Park paver on a level surface.
3. Stop engine.
4. Turn off 1/4 turn valves between hyĆ
draulic oil filters and oil tank.
5. Remove both hydraulic oil filters.
6. Turn filters counterclockwise to reĆ
move. Oil may leak out of filters.
Place a drain pan under the filters to
collect spilled oil.
7. Wipe a film of clean oil on new filter
seals.
8. Tighten filters until seal contacts
mounting surface. Hand tighten an
additional 1/2 turn.
9. Open cut off valves.
10. Start engine and operate hydraulic
system.
11. Check oil level and inspect for leaks.
CHANGING HYDRAULIC OIL:
Note: When changing and handling oil,
it is recommended to use protective
equipment to prevent skin exposure.
Properly dispose of used oil at a reputaĆ
ble disposal facility.
1. Park paver on a level surface.
2. Stop engine.
3. Remove drain plug and collect old oil.
4. Replace drain plug and fill tank.
5. Start engine and operate hydraulic
system.
6. Check oil level and inspect for leaks.