MBW CG200 - Manual (Page 22)

20
ATTACHING MOLDS:
1. Molds for the 12" hopper bolt diĆ
rectly to the rear hopper face.
2. Molds larger than 12" slide into the
tracks on the side unit frame. AdĆ
just the mold support rack as reĆ
quired to line up the mold. Tighten
all hardware and mounting nuts.
3. Adjust the front of the hopper with the grade blade 1" above zero grade and the
rear of the mold on zero grade. This will result in one inch of mold taper when
the paver is in its final position to pour. The mold taper provides a troweling
function on the concrete as it exits the mold. Lower the trim bars to prevent
concrete spill.
1.00"
Zero Grade