MBW CG200 - Manual (Page 25)

23
Set steering sensor location (Stringline height set at 20"
1.00"
Zero Grade
20.00" 20.00"
This is the position that the hopper and mold should be in while pouring.
4. Front steering sensor: Install senĆ
sor with potentiometer shaft facing
backward. Adjust sensor potenĆ
tiometer shaft so that screw driver
slot is horizontal. Install wand
hanging straight down with wand
weight to the inside. Tighten wand
counter balance weight to secure
wand to sensor.
5. Rear steering sensor: Install senĆ
sor with potentiometer shaft facing
backward. Adjust sensor potenĆ
tiometer shaft so that screw driver
slot is horizontal. Install wand
hanging straight down with wand
weight to the inside. Tighten wand
counter balance weight to secure
wand to sensor.
SENSOR SHAFTS ARE VERY FRAGILE. REMOVE SENSORS BEFORE
TRANSPORTING OR STORING MACHINE.
Note: Only one height sensor can be used at a time. Front (grade) or rear (pour).
Only one steering sensor can be used at a time. Front or rear.