MBW CG200 - Manual (Page 41)

39
7. Wipe a film of clean oil on the new filĆ
ter seal.
8. Tighten filter until seal contacts
mounting surface. Hand tighten an
additional 1/2 to 3/4 turn.
9. Replace drain plug and fill engine
with oil.
10. Run engine for a few minutes and
shut off.
11. Check oil level and inspect for leaks.
CLEANING ENGINE AIR FILTER:
1. Remove and inspect filter.
2. Clean or replace frequently in dusty
work conditions.
3. Replace filter. Ensure that all seals
seat properly.
CLEANING/REPLACING FUEL FILTER:
1. Stop engine.
To only drain water from fuel filter:
2. Place a drain pan under fuel filter and
loosen drain plug approximately 1
turn.
3. Water should drain. If necessary, opĆ
erate priming pump to drain water,
but only until fuel flows from filter.
4. Tighten drain plug. Goto step 9.
To replace fuel filter:
5. Remove drain plug (on bottom of filĆ
ter) and discard OĆring.
6. Remove fuel filter with filter wrench.
7. Screw new filter on by hand until gasĆ
ket contacts housing. Then tighten
1/3 turn more.
8. Install drain plug with new OĆring.
9. Operate priming mechanism on top
of filter.
10.Start engine. Check for leaks.
Primer
Filter
Drain Plug