MBW CG200 - Manual (Page 18)

16
STARTING THE ENGINE
1. Open fuel valves:
a. Fuel tank, front lower.
b. Fuel filter on engine.
2. Turn key to ON". Depress indicator
lamp test switch. Check function of inĆ
dicator lights.
a. OIL PRESSURE (LOW)
b. BATTERY (DISCHARGE)
c. FUEL LEVEL (LOW)
d. COOLANT TEMPERATURE
(HIGH).
3. Turn ignition key to PREHEAT". StanĆ
dard preheat times:
Temperature over 0°C (32°F): PreĆ
heat 15 seconds.
Temperature below 0°C (32°F): PreĆ
heat 30 seconds.
(Or until lamp glows bright red)
Preheating not req. with warm engine.
4. Turn key to START". After engine
starts, release key. If indicator lamps
glow longer than 10 seconds, stop enĆ
gine and correct problem.
Allow engine to warm up.
NEVER TURN THE KEY TO START WHILE THE ENGINE IS RUNNING.
DO NOT OPERATE STARTER LONGER THAN 10 SECONDS AT ONE TIME. IF
THE ENGINE FAILS TO START, WAIT 60 SECONDS AND TRY AGAIN.