MBW CG200 - Manual (Page 40)

38
PERIODIC MAINTENANCE
ALWAYS STOP ENGINE BEFORE PERĆ
FORMING MAINTENANCE PROCEDURES.
REMOVE IGNITION KEY AND ALLOW ENĆ
GINE TO COOL.
THE ENGINE SLIDES OUT OF THE MAIN
UNIT FOR SERVICE. REMOVE THE LOCK
PIN AND LOCK PLATE FROM THE RIGHT
ENGINE TRACK (WHILE VIEWING ENGINE).
FIRMLY PULL ENGINE BACK INTO PLACE
AND REPLACE THE LOCK PLATE AND PIN
BEFORE STARTING THE ENGINE.
CHECKING ENGINE OIL LEVEL:
1. Park paver on level surface.
2. Clean dirt from around dipstick and
oil filler areas to prevent dirt from falĆ
ling into engine.
3. Remove dipstick and check oil level.
4. Add oil as required to maintain level
between upper ("Full") mark and lowĆ
er ("Low") mark. See Lubrication
Chart" for proper oil type.
CHANGING ENGINE OIL AND FILTER:
Note: When changing and handling oil,
it is recommended to use protective
equipment to prevent skin exposure.
Properly dispose of used oil at a reputaĆ
ble disposal facility.
1. Park paver on level surface.
2. Run engine a few minutes to warm
oil.
3. Stop engine.
4. Remove oil pan drain plug.
5. Turn the filter counterclockwise to reĆ
move.
6. Place a drain pan under the filter to
collect soiled oil.