AEM 30-2340 4-Channel Wideband UEGO AFR Controller - Manual (Page 3)

Page 3 10-2340 Rev 05 121012
KIT CONTENTS
1 x 35-2340 4 CH UEGO Module
1 x 35-2908 Wiring Harness
1 x 35-4008 UEGO Stainless Steel Bung
1 x 30-2001 UEGO Sensor
4 x 1-2059
6-32 Stainless Steel Hex Nut
4 x 1-2047 6-32 x 1 ¼ screw
1 x 10-2340 Installation Instructions
INSTALLATION TIPS
1. Read through the entire manual and instructions before beginning the
installation.
2. Disconnect the negative battery cable(s) before beginning any work.
3. Maintain a clean and neat work area through out the installation.
4. When raising or working under a vehicle, use properly rated stands/jacks.
5. Make sure all connectors are fully seated and inserted.
6. Make sure all components and cables are routed and installed away from any
direct heat sources or sharp objects.
TABLE OF CONTENTS
•
Sensor Mounting…………………………………………..4
•
Controller Mounting…………………………………….....4
•
Power Connections…………………………………….....5
•
AEMnet Connections…………………………....………...6
o AEMnet products………………………………..…6
o Series 2 EMS……………………………………....7
o Non AEM Products………………………………...8
•
Cylinder Numbering and Mode Selection…………….....9
•
Analog Outputs…………………………………………...11
o EMS………………………………………………...12
•
Exhaust Back Pressure Compensation………………..14
•
Indicator Lights……………………………………………14
•
Series 2 EMS AEM Tuner Configuration………………15
•
UEGO Connector Pinout………………………………...17
•
Specifications……………………………………………..18
•
Notes……………………………………………………….18
•
Replacement/Optional Parts…………………………….18
•
AEMnet message Structure……………………………..18
•
Appendix A………………………………………………..19
•
Warranty …………………………………………………..30