Brother DCP1200 - Manual (Page 44)

C O N N E C T I N G T O A P C 4 - 2
Computer Requirements
The following are the minimum computer requirements you need to set up
and operate the MFC as a printer.
CPU 80486/66MHz or higher (Windows ® 3.1x or 95)
Pentium 75 or Higher (Windows ® 98 or
Windows NT ® Workstation Version 4.0)
RAM 8MB or greater for Windows ® 3.1x
8MB or greater for Windows ® 95
(16MB recommended)
16MB or greater for Windows ® 98 or Windows NT ®
Workstation Version 4.0 (32MB recommended)
Hard Disk Drive 50MB Available Disk Space
Operating System Windows ® 3.1x, 95/98 or NT ® Workstation Version
4.0, DOS environment compatible with your
Windows
® version
Use only a shield interface cable that is IEEE-1284 compliant, and that is
less than 6 feet long (1.8 meters), or a USB cable.
Connections
Connecting a USB Cable (For Windows ® 98,
USB-Equipped Power Macintosh ® G3 and iMac ™ )
Please find your Windows ® 98 CD-ROM before you begin.
A USB cable is not included with your copier/printer. Before you can set
up the USB interface, you must purchase a standard USB cable. Or, if you
prefer to set up the bundled parallel cable, please see “Connecting the
Bundled Parallel Cable”.
1 After you have set up the copier/printer and checked that it is working
properly, make sure it is turned on and your PC is turned off.