BNC 835-3 Programmer Manual - Manual (Page 37)

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 37 of 37
OFF(0) This command disables device identification by clearing the message on the
signal generator's front panel and returning the LAN Status indicator to display the
current network state. For more information, refer to the Programming Guide.
:LAN:IP
:SYSTem:COMMunicate:LAN:IP
:SYSTem:COMMunicate:LAN:IP?
This command sets the signal generator’s local area network (LAN) internet protocol (IP)
address for your IP network connection.
:LAN:KEEP:TIMeout (not implemented)
:SYSTem:COMMunicate:LAN:KEEP:TIMeout
:SYSTem:COMMunicate:LAN:KEEP:TIMeout?
This command sets the length of time for the TCP Keep Alive setting.
Range 0 sec to 3600 sec
:LAN:RESTart
:SYSTem:COMMunicate:LAN:RESTart
This command restarts the network to enable changes that have been made to the LAN
setup.
:LAN:SUBNet
:SYSTem:COMMunicate:LAN:SUBNet
:SYSTem:COMMunicate:LAN:SUBNet?
This command sets the signal generator’s local area network (LAN) subnet mask address
for your internet protocol (IP) network connection.
:SOCKet:ECHO
:SYSTem:COMMunicate:SOCKet:ECHO
This command turns the echo from the 835-3 controller on or off. Echo is typically turned
on only for a telnet session. The 835-3 returns a “>>” prompt when ready.
UNIT Subsystem
Command Parameters Unit (default) Remark
UNIT:POWer W|V|DBM|DB DBM
UNIT:FREQuency HZ|MHZ|GHZ HZ
UNIT:POWer
UNIT:POWer W|V|DBM|DB
*RST DBM
UNIT:FREQuency
UNIT:FREQuency HZ|MHZ|GHZ
*RST HZ
Company Details
Address: Berkeley Nucleonics
2955 Kerner Blvd.
San Rafael, CA 94901
Phone: (415) 453-9955
Fax: (415) 453-9956
Email:
[email protected] / web: www.berkeleynucleonics.com