beautypg.com

BNC 835-3 Programmer Manual User Manual

Page 20

background image

Berkeley Nucleonics
www.Berkeley Nucleonics.com

835-3

Programmer’s Manual v1.0

Page 20 of 37

mode, frequency is determined by programmed values for
:LIST:FREQuency.

:FREQuency:STARt
[SOURce]:FREQuency:STARt
[SOURce]:FREQuency:STARt?
This command sets the first frequency point in a step sweep.
*RST The preset value is 1 GHz. Please refer to the Data Sheet.
Range Please refer to the Data Sheet.

:FREQuency:STOP
[SOURce]:FREQuency:STOP
[SOURce]:FREQuency:STOP?
This command sets the last frequency point in a step sweep.
*RST The preset value is 2 GHz.
Range Please refer to the Data Sheet.

[SOURce]:FREQuency:STEP
[SOURce]:FREQuency:STEP[:LINear]
This command sets the step size for a linear step sweep.

[SOURce]:FREQuency:STEP:LOGarithmic
[SOURce]:FREQuency:STEP:LOGarithmic
This command sets the step size for a logarithmic step sweep.

[SOURce]:PHASe Subsystem

Command

Parameters

Unit

(default)

Remark

[SOURce]:PHASe:REFerence

radians

FW2.4

[SOURce]:PHASe[:ADJust]

radians


:PHASe:REFerence
[SOURce]:PHASe:REFerence
This command sets the current output phase as a zero reference. Subsequent phase
adjustments are set relative to the new reference.

:PHASe[:ADJust]
[SOURce]:PHASe[:ADJust]
[SOURce]:PHASe[:ADJust]?
This command adjusts the phase of the signal. The query will only return values in
radians.
*RST The preset value is 0.

[SOURce]:POWer Subsystem

Command

Parameters

Unit

(default)

[SOURce]:POWer[:LEVel][:IMMediate][:AMPLit
ude]

dBm

[SOURce]:POWer:MODE

FIXed|LIST|SWE

FIXed