BNC 835-3 Programmer Manual - Manual (Page 36)

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 36 of 37
This command enables the user to change the maximum length of time that the
instrument will spend trying to acquire an IP address using DHCP. If the LAN Config Type
is set to Auto, then the Auto- IP protocol will be used as a fall- back when time- out does
occur. The DHCP timeout value is stored in the same non- volatile ram as the other LAN
configurations. The query returns the current setting, not the saved setting.
Default 30 Seconds
:LAN:DOMain (not implemented)
:SYSTem:COMMunicate:LAN:DOMain
:SYSTem:COMMunicate:LAN:DOMain?
This command defines the domain name of the signal generator’s DNS server. This entry
defines the DNS server for the signal generator LAN connection. The query returns the
current setting, not the saved setting.
:LAN:DNS:DYNamic (not implemented)
:SYSTem:COMMunicate:LAN:DNS:DYNamic ON|OFF|1|0
:SYSTem:COMMunicate:LAN:DNS:DYNamic?
This command turns dynamic Domain Name System (DNS) on/off. The query returns the
current setting, not the saved setting.
:LAN:DNS:OVERride (not implemented)
:SYSTem:COMMunicate:LAN:DNS:OVERride ON|OFF|1|0
:SYSTem:COMMunicate:LAN:DNS:OVERride?
This command enables you to override the DNS server that is returned by the DHCP
server. The LAN configuration type must be set to Auto or DHCP to use this feature. The
query returns the current setting, not the saved setting.
:LAN:DNS[:SERVer] (not implemented)
:SYSTem:COMMunicate:LAN:DNS[:SERVer]
:SYSTem:COMMunicate:LAN:DNS[:SERVer]?
This command defines the IP address of the signal generator DNS server. This entry
defines the DNS server for the signal generator LAN connection. The query returns the
current setting, not the saved setting.
:LAN:GATeway
:SYSTem:COMMunicate:LAN:GATeway
:SYSTem:COMMunicate:LAN:GATeway?
This command sets the gateway for local area network (LAN) access to the signal
generator from outside the current sub- network. The query returns the current setting,
not the saved setting.
:LAN:HOSTname
:SYSTem:COMMunicate:LAN:HOSTname
:SYSTem:COMMunicate:LAN:HOSTname?
This command sets the signal generator’s local area network (LAN) connection hostname.
Maximum 29 characters are allowed. The query returns the current setting, not the saved
setting.
:LAN:IDENtify (not implemented)
:SYSTem:COMMunicate:LAN:IDENtify ON|OFF|1|0
This command controls the LAN identify feature. ON(1) The command enables device
identification by displaying the full- screen message
"Identify: " on the signal generator's front panel; the LAN Status indicator
will also show "IDENTIFY". For more information, refer to the Programming Guide.