BNC 835-3 Programmer Manual User Manual
Page 23

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 23 of 37
[SOURce]:LIST:MANual
FW2.4
[SOURce]:LIST:MODE
AUTO | MANual
FW2.4
[SOURce]:LIST:POWer
dBm
[SOURce]:LIST:POWer:POINts?
[SOURce]:LIST:COUNt
1
:LIST:DIRection
[SOURce]:LIST:DIRection UP|DOWN|RANDom
[SOURce]:LIST:DIRection?
This command sets the direction of a list or step sweep. UP This choice enables a sweep
in an ascending order:
• first to last point for a list sweep
• start to stop for a step sweep
DOWN This choice reverses the direction of the sweep.
*RST UP
:LIST:DWELl
[SOURce]:LIST:DWELl
[SOURce]:LIST:DWELl:POINts?
This command sets the dwell time for the current list sweep points. Dwell time is used
when IMMediate is the trigger source. The dwell time is the amount of time the sweep is
guaranteed to pause after setting the frequency and/or power for the current point.
The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
The variable
:LIST:DELay
[SOURce]:LIST:DELay
[SOURce]:LIST:DELay:POINts?
This command sets the off time for the current list sweep points. Off time is used when
IMMediate is the trigger source. The off time is the amount of time the output is
guaranteed to be blanked after setting the frequency and/or power for the current point
to suppress output transients during a frequency change.
The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
The variable
:LIST:DELay:AUTO
[SOURce]:LIST:DELay:AUTO ON|OFF|1|0
This command enabled the automatic blanking of the output during transients between
two frequency steps.
*RST ON
:LIST:FREQency:POINts
[SOURce]:LIST:POINts?
This command queries the signal generator for the number of frequency points in the
current list sweep file.
:LIST:FREQuency
[SOURce]:LIST:FREQuency
[SOURce]:LIST:FREQuency?
This command sets the frequency values for the current list sweep points.
The maximum number of list sweep points is 3’501.