BNC 835-3 Programmer Manual - Manual (Page 33)

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 33 of 37
This command sets a modulo on consecutive trigger events. Setting the value to N
means that only every Nth trigger event will be considered. Setting it to one means will
use every trigger event that does not occur during a running sweep.
*RST 1
Range 1 to 255
:STATus Subsystem
This subsystem controls the status-reporting structures.
Command Parameters Unit
(default)
Remark
:STATus:OPERation[:EVENt]? Firmware 2.21
:STATus:OPERation:CONDition? Firmware 2.21
:STATus:OPERation:ENABle Firmware 2.21
:STATus:OPERation:PTR Firmware 2.21
:STATus:OPERation:NTR Firmware 2.21
:STATus:PREset Firmware 2.21
:STATus:QUEStionable[:EVENt]? Firmware 2.21
:STATus:QUEStionable:CONDition? Firmware 2.21
:STATus:QUEStionable:ENABle Firmware 2.21
:STATus:QUEStionable:PTR Firmware 2.21
:STATus:QUEStionable:NTR Firmware 2.21
:OPERation?
:STATus:OPERation[:EVENt]?
This query returns the contents of the operation status event register and clears it.
:OPERation:CONDition?
:STATus:OPERation:CONDition?
This query returns the contents of the operation status condition register.
:OPERation:ENABle
:STATus:OPERation:ENABle
This command sets the enable mask of the operation status event register.
:OPERation:PTR
:STATus:OPERation:PTR
This command sets the positive transition filter of the operation status event register.
:OPERation:NTR
:STATus:OPERation:NTR
This command sets the negative transition filter of the operation status event register.
:PRESet
:STATus:PRESet
Disables all status events, clears all negative transition filters and sets all positive
transition filters.