BNC 835-3 Programmer Manual User Manual
Page 24
Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 24 of 37
The variable
The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
Range Please refer to the Data Sheet.
:LIST:MANual
[SOURce]:LIST:MANual
[SOURce]:LIST:MANual?
This command sets a list or step sweep point as the current sweep point controlling the
frequency and power output. If list or step mode is controlling frequency or power, or
both, then the indexed point in the respective list(s) will be used.
Entering a value with this command will have no effect, unless MANual is the selected
mode. Refer to
:LIST:MODE
command for setting the proper mode.
If the point selected is beyond the length of the longest enabled list, then the point will
be set to the maximum possible point, and an error will be generated.
Range 1–3’501
:LIST:MODE
[SOURce]:LIST:MODE AUTO|MANual
[SOURce]:LIST:MODE?
This command sets the operating mode for the current list or step sweep.
AUTO
This choice enables the selected sweep type to perform a sweep of all
points.
MANual
This choice enables you to select a single sweep point. The selected point
controls the frequency and/or amplitude according to the sweep type.
Refer to
:LIST:MANual
command for selecting a sweep point.
*RST AUTO
:LIST:POWer
[SOURce]:LIST:POWer
[SOURce]:LIST:POWer?
This command sets the amplitude for the current list sweep points.
:LIST:POWer:POINts
[SOURce]:LIST:POWer:POINts?
This command queries the number of power points in the current list sweep file.
:LIST:COUNt
[SOURce]:LIST:COUNt
[SOURce]:LIST:COUNt?
This command sets the number of consecutive times the list is executed on each sweep
start.
The variable
[SOURce]:LFOutput Subsystem
Command
Parameters
Unit
(default)
[SOURce]:LFOutput:AMPLitude
1 V
[SOURce]:LFOutput:FREQuency
400 Hz
[SOURce]:LFOutput:STATe
ON|OFF|1|0
OFF
[SOURce]:LFOutput:SHAPe
SINE|TRIangle|SQUare
SINE
[SOURce]:LFOutput:SOURce
LFGenerator|PULM|TRIGger
LFG