BNC 835-3 Programmer Manual - Manual (Page 28)

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 28 of 37
: FM:DEViation
[SOURce]:FM:SENSitivity
[SOURce]:FM: SENSitivity?
This command sets the frequency modulation deviation. This setting will be used if
:FM:SOURce is set to LFGenerator.
The variable is expressed in units of Hertz.
*RST 10000
: FM:SENSitivity
[SOURce]:FM:SENSitivity
[SOURce]:FM: SENSitivity?
This command sets the frequency modulation deviation per one volt peak amplitude
signal input. This setting will be used if :FM:SOURce is set to EXTernal.
The variable is expressed in units of Hertz per Volt.
*RST 10000
: FM:SOURce
[SOURce]:FM:SOURce EXTernal|LFGenerator
[SOURce]:FM:SOURce?
This command selects the FM modulation signal source. If LFGenerator is selected, the
device’s function output has to be connected to the FM/PM input (at the rear panel).
*RST EXT
: FM:STATe
[SOURce]:FM:STATe ON|OFF|1|0
[SOURce]:FM:STATe?
This command turns the frequency modulation on or off.
*RST OFF
[SOURce]:PM Subsystem (Phase Modulation)
8
Command Parameters Unit (default)
[SOURce:]PM:DEViation 1 rad
[SOURce:]PM:SENSitivity 1 rad/V
[SOURce:]PM:SOURce EXTernal|LFGenerator EXT
[SOURce:]PM:STATe ON|OFF|1|0 OFF
: PM:DEViation
[SOURce]:PM:SENSitivity
[SOURce]:PM: SENSitivity?
This command sets the phase modulation deviation. This setting will be used if
:PM:SOURce is set to LFGenerator.
The variable is expressed in units of radians.
*RST 1
: PM:SENSitivity
[SOURce]:FM:SENSitivity
[SOURce]:FM: SENSitivity?
This command sets the phase modulation deviation per one volt peak amplitude signal
input. This setting will be used if :PM:SOURce is set to EXTernal.
The variable is expressed in units of radians per Volt.
*RST 1