BNC 835-3 Programmer Manual - Manual (Page 21)

Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 21 of 37
ep
[SOURce]:POWer:STARt dBm
[SOURce]:POWer:STOP dBm
[SOURce]:POWer:ALC ON | OFF | 1 | 0 ON
[SOURce]:POWer:ALC:HOLD ON | OFF | 1 | 0 OFF
[SOURce]:POWer:ATTenuation dB FW2.219
[SOURce]:POWer:ATTenuation:AUTO ON | OFF | 1 | 0 ON FW2.219
[SOURce]:POWer:ATTenuation:LIST? FW2.219
[:LEVel][:IMMediate][:AMPLitude]
[SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]
[SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]?
This command sets the RF output power.
:MODE
[SOURce]:POWer:MODE CW|LIST|SWEep
[SOURce]:POWer:MODE?
This command sets the signal generator power mode to fixed or swept.
FIX
This choice stops a power sweep, allowing the signal generator to
operate at a fixed power level. Refer to
[:LEVel][:IMMediate][:AMPLitude] command for setting the output
power level.
LIST or SWEep This choice selects the swept power mode. If sweep triggering is set
to immediate along with continuous sweep mode, executing the
command starts the LIST or STEP power sweep.
:STARt
[SOURce]:POWer:STARt
[SOURce]:POWer:STARt?
This command sets the first amplitude point in a step sweep.
Range
:STOP
[SOURce]:POWer:STOP
[SOURce]:POWer:STOP?
This command sets the last amplitude point in a step sweep.
Range
:ALC
[SOURce]:POWer:ALC ON|OFF|1|0
[SOURce]:POWer:ALC?
This command turns the automatic power level control on and off.
:ALC:HOLD
[SOURce]:POWer:ALC:HOLD ON|OFF|1|0
[SOURce]:POWer:ALC?
(Devices with option PE only)
This command sets the automatic level control into hold mode. The amplitude level
control loop is open.
:ATTenuation
[SOURce]:POWer:ATTenuation
[SOURce]:POWer:ATTenuation?
(Devices with option PE only)