BNC 835-3 Programmer Manual User Manual
Page 26
Berkeley Nucleonics
www.Berkeley Nucleonics.com
835-3
Programmer’s Manual v1.0
Page 26 of 37
[SOURce]:SWEep:DIRection
UP | DOWN | RANDom
UP
[SOURce]:SWEep:POINts
2 to 3855
3855
[SOURce]:SWEep:DWELl
s
[SOURce]:SWEep:DELay
s
[SOURce]:SWEep:DELay:AUTO
ON|OFF|1|0
ON
[SOURce]:SWEep:SPACing
LINear | LOGarithmic
[SOURce]:FREQuency:MODE
CW | SWEep | LIST
[SOURce]:FREQuency:STARt
fmin to fmax
Hz
[SOURce]:FREQuency:STOP
fmin to fmax
Hz
[SOURce]:POWer:MODE
CW | LIST | SWEep
[SOURce]:POWer:STARt
dBm
[SOURce]:POWer:STOP
dBm
:DIRection UP|DOWN|RANDom
[SOURce]:SWEep:DIRection UP|DOWN|RANDom
:SWEep:POINts
[SOURce]:SWEep:POINts
[SOURce]:SWEep:POINts?
This command defines the number of step sweep points.
*RST 101
Range 2–3501
:SWEep:DWELl
[SOURce]:SWEep:DWELl
[SOURce]:SWEep:DWELl?
This command sets the dwell time for the current step sweep points. Dwell time is used
when IMMediate is the trigger source. The dwell time is the amount of time the sweep is
guaranteed to pause after setting the frequency and/or power for the current point.
The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
The variable
:SWEep:DELay
[SOURce]:SWEep:DELay
[SOURce]:SWEep:DELay?
This command sets the off time for the current step sweep points. Off time is used when
IMMediate is the trigger source. The off time is the amount of time the sweep is
guaranteed to pause after setting the frequency and/or power for the current point.
The setting enabled by this command is not affected by signal generator power- on,
preset, or *RST.
The variable
:SWEep:SPACing
[SOURce]:SWEep:SPACing LINear|LOGarithmic
[SOURce]:SWEep:SPACing?
This command enables the signal generator linear or logrithmic sweep modes. These
commands require the signal generator to be in step mode.
The instrument uses the specified start frequency, stop frequency, and number of points
for both linear and log sweeps.
*RST LIN