BNC 745-20C-T - Manual (Page 18)

User's Manual - MOD745-20 October 2014
Page 18 / 30
6. R
EMOTE CONTROL
6.1. Connection
To connect over the LAN, follow these steps:

Connect the instrument LAN connector to the remote control computer,

On the user interface, either specify the LAN address,

On the remote controlcomputer , enter the instrument’s IP address,

After the connection has been established, the following commands can be used to modify the
settings:
o Set the instrument’s IP address with: IP XXX.XXX.XXX.XXX
o Query the instrument’s IP address with: IP? 
:IP XXX.XXX.XXX.XXX
o Set the instrument’s IP mask with: NM XXX.XXX.XXX.XXX
o Query the instrument’s IP mask with: NM? 
:NM XXX.XXX.XXX.XXX
o Set the instrument’s IP gateway: GW XXX.XXX.XXX.XXX
o Query the instrument’s IP gateway with: GW? 
:GW XXX.XXX.XXX.XXX
6.2. Command structure
MOD745-20 is compatible with all command of the LIL timing system.
Each command description has at least some of the following items:

Full command syntax

Form Set / Query

Brief description

Parameters

RST value

Specified limits

Example