BNC 745-20C-T - Manual (Page 15)

User's Manual - MOD745-20 October 2014
Page 15 / 30
5.3. Sub-
menu “Width”
Tapping in the “WIDTH” window on the “PULSE SETUP OUTPUT” sub-menu will open another sub-menu
with the width settings of the channel depicted in the following figure.
To set the channel width, enter the value with the numbers in nanoseconds, then tapping on the validate
button will send the setting.
Erase
Exit sub-menu
Validate
Note: Out of range values are rejected.
5.4. Sub-menu “INTERNAL FREQUENCIES SETUP”
Tapping in the “INTERNAL FREQUENCIES” window on the main menu will open a sub-menu with the
internal frequencies settings depicted in the following figure.
To set the frequencies, tap on the window corresponding to the internal frequency to configure.
Notes:
- F1 is the highest frequency.
- F3 is the lowest frequency.