BMW K 1100 LT/RS - Manual (Page 98)

12.12
• Remove regulator (8) with carbon brushes.
• Carefully lift out armature (9) together with bear-
ing (10).
• Remove bearing (10) from armature shaft.
• Unsolder stator (11) on diode plate (12); mark the
wires.
• Remove diode plate.
• Remove O-ring (14).
• Install in the reverse order of removal.
L
Note:
During assembly, insulate the solder points on the
diode plate with silicone. Coat bearing seat in hous-
ing with Molykote paste.
Checking exciter winding
• Using the test probes of the BMW diagnosis test-
er,
BMW No. 61 1 510 , measure the resistance
across the slip rings.
Nominal resistance.......................................7 ± 1 Ω
LT120100
9
11
10 14 13
8
12
61 1 510
LT120110