BMW K 1100 LT/RS - Manual (Page 202)

23.28
Re-assembling motorcycle
• Install battery.
• Intall Motronic control unit.
• [ABS II] Install ABS unit.
• Install battery.
• Intall Motronic control unit.
• [ABS I] Install control unit.
• Install swinging arm.
• Install footrest plates.
• [ABS I] Install pressure modulators.
• Install rear wheel drive.
• Install suspension strut.
• Install rear wheel.
• Install brake caliper
L
Note:
Check ABS sensor gap.
• Install exhaust system.
• Install rear mudguard.
• Install side section of fairing.
X
Tightening torques:
Fixed swinging arm bearing at geabox ........... 8 Nm
Fixed swinging arm bearing journal,
free bearing ................................................. 7.5 Nm
Locknut, free bearing ................................... 41 Nm
Bearing pin of fixed bearing ....................... 150 Nm
(clean thread + Loctite 2701)
Bearing pin of loose bearing .......................... 7 Nm
(clean thread + Loctite 2701 applied to entire
length of thread on loose bearing pin)
Locknut ...................................................... 105 Nm
Suspension strut to frame/rear wheel drive .. 51 Nm
Rear wheel studs ....................................... 105 Nm
Exhaust pipes to cylinder head .................... 21 Nm
Exhaust system to holder/footrest plate ......... 9 Nm
Front silencer (muffler) to gearbox ................ 12 Nm
Footrest plate to gearbox ............................. 15 Nm