BMW K 1100 LT/RS - Manual (Page 69)

11.35
Assembling the crankcase
• Install O-rings (6,7) for the water and oil passag-
es.
• Coat the sealing faces (which must be free from
oil and grease) lightly with 3-Bond-1209.
• Place the two halves of the housing together.
• Screw in bearing bolts (4, 5) for the shouldered
and needle roller bearings, and tighten alternate-
ly.
X
Tightening torques:
Shouldered bearing (4) ................................. 40 Nm
Needle roller bearing (5) ............................... 18 Nm
Retaining screws of two halves of the housing7 Nm
1
2
3
4
5
LT110530
6
7
KR110521
Installing oil mesh strainer
• Note presence of O-ring (2).
Installing oil filter
• Coat the oil filter sealing ring with oil.
• Do not tighten the oil filter more than half a turn
beyond the point where it makes contact.
Installing oil sump
• Coat the sealing faces (which must be free from
oil and grease) with 3-Bond 1209.
X
Tightening torques:
Retaining screws............................................ 7 Nm
Oil filter......................................................... 11 Nm