BMW K 1100 LT/RS - Manual (Page 75)

11.41
Installing combined oil-water pump
• Apply a thin coat of 3-Bond 1209 to the sealing
faces, which must be free of oil and grease.
• Place O-ring on water passage.
• Insert the input pinion into the output shaft with
an oiled O-ring.
• Attach the pump housing and insert the screws
loosely at first.
L
Note:
Turn the crankshaft several times in order to centre
the gearwheels, at the same time gradually tighten-
ing the retaining screws.
• Tighten the retaining screws fully.
X
Tightening torque:
Pump housing to crankcase........................... 7 Nm
• Insert the wire for the oil pressure telltale and
temperature display through the housing and
connect it.
• Apply a thin coat of 3-Bond to the sealing faces
on the cover and housing, which must be free
from oil and grease.
• Place the housing cover in position and tighten it.
X
Tightening torque:
Cover to pump housing.................................. 7 Nm