Removing timing chain cover, Removing the hall-effect signal transmitter, Remove the crankshaft cover – BMW K 1100 LT/RS User Manual
Page 53: Removing cylinder head cover, Removing and installing sealing ring in timing cas
11.19
Removing timing chain cover
Removing the Hall-effect signal transmitter
•
Remove cover (1).
•
Take off gasket (2).
•
Remove Hall-effect signal transmitter (3), noting
the semi-circular shim washers.
L
Note:
Mark the correct installed position of the adjusting
washer on the engine block, or remove it in the TDC
position.
•
Remove gate rotor (4) and take off adjusting
washer (5).
Remove the crankshaft cover
•
Detach the coolant hose at the water pump and
radiator.
•
Remove the cover.
Removing cylinder head cover
•
Remove the ignition leads.
•
Remove the cylinder head cover.
Removing and installing sealing ring in timing
case cover
•
Drive the sealing ring out with a suitable drift.
•
Drive the sealing ring in from the inside using
handle, BMW No. 00 0 500, and drift,
BMW No. 11 1 610.
1
2
3
4
5
LT110200
LT110210