Philips Pronto Home Theater Control Panel TSU3500 - Manual (Page 12)

User Guide
12
Before You Start
30° to 45°
1 Plug the power adapter into a wall outlet and connect it to the docking
station.
2 Slide the Pronto in the
docking station until it clicks.
Charging starts immediately. The blue charging LEDs on the front of the docking
station indicate that the battery pack is being charged.
When the Pronto is fully charged, the charging LEDs switch off. Normal charging
time is 2 to 3 hours, depending on the condition of the battery pack.
When the charging LEDs are flashing, an error has occurred. Try one of the
following:
■ Make sure the battery pack is properly installed in your Pronto.
■ Make sure the Pronto is placed properly in the docking station.
■ Check if the connector in the docking station is clean and free of obstructions.
■ Cool down the battery pack.
3 When the Pronto is fully charged, take it out of the docking station.
Make sure that you first tilt the Pronto to an angle of 30° to 45° and then take
it out of the docking station.
ProntoNG_0705_ML_1EN.qxd 22-08-2005 10:57 Pagina 12