Burnham V9A - Manual (Page 26)

26
8. Combination Label and Burnham Logo Plate were
attached to jacket front panel at time of manufacture.
If loose or peeling, apply pressure to reset adhesive.
9. On steam boilers, attach lowest permissible water
level plate (from steam trim carton) to the front
panel using sheet metal screws.
10. Tighten all sheet metal screws to complete jacket
assembly.
F. BURNER MOUNTING PLATE - Refer to Figures 16
and 23.
1. Using silastic sealant, secure the 3/16” diameter
rope gasket to the groove along the mounting plate
opening in the front section.
2. Install 5/16” x 1” lg. cap screw in lower tapping on
front section to carry weight of burner mounting
plate.
3. Engage bottom slot on burner mounting plate with
matching bolt in bottom tapping of front section.
Align mounting holes and fasten the mounting plate
to the boiler sections with seven (7) remaining 5/16”
cap screws and washers. Fully tighten all bolts.
G. MOUNT BURNER ADAPTER PLATE TO
BURNER MOUNTING PLATE.
Refer to Figures 16 and 23. ALSO, REFER TO
BURNER INSTALLATION MANUAL FOR
INSTRUCTIONS SPECIFIC TO EACH BURNER.
1. In all cases, the burner adapter plate carton for the
specified burner will be provided by Burnham.
2. Open Adapter Plate carton and remove contents.
Apply four (4) small dabs of silastic on rear surface
of adapter plate to temporarily hold gasket in
place. Hold adapter plate in position against burner
mounting plate, align holes and secure with five (5)
3/8” lock washers and 3/8” x 7/8” lg. cap screws.
3. USE A HOLE SAW OR KNIFE TO CUT
BURNER MOUNTING PLATE INSULATION
TO MATCH HOLE SIZE ON BURNER
ADAPTER PLATE. After cutting, remove any and
all loose pieces of insulation which may become
lodged or interfere with the head of a burner air tube
after insertion.
4. Confirm that hole in insulation fits snugly around
burner blast tube. If hole is oversized, remove
burner mounting plate (with burner attached) from
boiler. Use additional fiberglass rope gasket
provided with burner to fill in any space between
Figure 23: Burner Mounting Plate/Burner Adapter Plate Options