Boss Audio Systems GT-6 - Manual (Page 82)

82
Adjusting the Expression Pedal
Although the GT-6’s expression pedal has been set for
optimum operation at the factory, extended use and the
operating environment can result in the pedal going out of
adjustment.
If you encounter problems such as being unable to fully cut
off the sound with the volume pedal, you can use the
following procedure to readjust the pedal.
1. Hold down [PEDAL ASSIGN] while you switch on the
power.
The following messages alternate in the display.
fig.10-801
2. With the pedal completely released, press [WRITE].
The message “--- OK! ---” appears, and then the
following messages alternate in the display.
fig.10-802
* If you press [WRITE] when the pedal is not completely
released, or when the pedal position (angle) is not correct, the
message “--- Area Over! ---” appears in the display, and you
are prevented from proceeding to the next step. If this occurs,
readjust the pedal position.
3. With the pedal fully depressed, press [WRITE].
“--- OK! ---” appears, followed by "press [EXIT]."
* If you press [WRITE] when the pedal is not fully depressed, or
when the pedal position (angle) is not correct, the message
“--- Area Over! ---” appears in the display, and you are
prevented from proceeding to the next step. If this occurs,
readjust the pedal position.
4. Press [EXIT].
After the message “Checking data please wait...” has
been displayed, you'll be returned to the Play screen.