Boss Audio Systems GT-6 - Manual (Page 63)

63
Chapter 8 Other Features
Chapter
8
Setting the External Foot Switch
Functions (SUB CTL 1, 2 Function)
This sets the foot switch functions for “Sub Control 1” and
“Sub Control 2” when you have an external foot switch
connected to the rear panel’s SUB EXP PEDAL/SUB CTL1,2
jack.
* When connecting two foot switches using the special optional
Roland PCS-31 connector cord, the foot switch connected with
the white-banded plug functions according to the Sub Control
1 settings, and the foot switch connected with the red-banded
plug functions according to the Sub Control 2 settings.
* When you have only one foot switch connected, the Sub
Control 1 settings are used.
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “SubCTL 1 Func” or “SubCTL 2 Func” is
displayed.
fig.08-07
2. Rotate the PATCH/VALUE dial to set the Knob mode.
Assignable:
The controller set in each patch’s Pedal Assign is used.
MANUAL On/Off:
The foot switch is used as a manual On/Off switch.
Use a momentary-type foot switch (such as the optional
FS-5U).
TUNER On/Off:
The foot switch is used as a tuner On/Off switch.
Use a momentary-type foot switch (such as the optional
FS-5U).
MIDI Start/Stop:
The foot switch is used for starting and stopping a
connected MIDI device (for example a sequencer).
MMC Play/Stop:
The foot switch is used for controlling Play and Stop for
the connected MIDI device (such as a hard disk
recorder).
3. Press [EXIT] to return to the Play screen.