Boss Audio Systems GT-6 - Manual (Page 31)

31
Chapter 4 The Effects Explained
Chapter
4
When Type Is Set to Custom1–3
You can select the following parameters when TYPE is set to
Custom1–3.
Making “Custom” Pedal Wah Settings (p. 55)
Parameter value
Custom Type (1–3) CRY WAH, VO WAH, Fat WAH,
Light WAH, 7String WAH
Custom Q (1–3) -50–+50
Custom Range Low (1–3) -50–+50
Custom Range High (1–3) -50–+50
Custom Presence (1–3) -50–+50
Pdl Position (pedal position)
This adjusts the position of the wah pedal.
Level
Adjusts the volume.
■ AW (Auto Wah)
Mode
Selection for the wah mode.
LPF (low pass filter):
This creates a wah effect over a wide frequency range.
BPF (band pass filter):
This creates a wah effect in a narrow frequency range.
Polarity
Selection for the direction in which the filter will change in
response to the input.
Up:
The frequency of the filter will rise.
Down:
The frequency of the filter will fall.
Sens (sensitivity)
This adjusts the sensitivity at which the filter will change in
the direction determined by the polarity setting. Higher
values will result in a stronger response. With a setting of
“0,” the strength of picking will have no effect.
Frequency
This adjusts the center frequency of the Wah effect.
Peak
Adjusts the way in which the wah effect applies to the area
around the center frequency. Lower values will produce a
wah effect over a wide area around the center frequency.
Higher values will produce a wah effect in a narrow area
around the center frequency.
* With a value of “50” a standard wah sound will be produced.
Rate
Adjusts the frequency of the auto wah.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [
] to display
the Master BPM settings screen.
Depth
Adjusts the depth of the auto wah effect.
Level
Adjusts the volume.
■ FW (Fixed Wah)
Provides the effect obtained when a filter-type effect is used
with the wah pedal stopped at a given position.
Type
This selects the wah type.
For more on the effect of each type, refer to “Pedal Wah.”
Pdl Position (pedal position)
This adjusts the position of the wah pedal.
* If this parameter is assigned to an external expression pedal,
operating the pedal then provides the same effect as the pedal
wah effect.
Level
Adjusts the volume.