Factory settings, Restoring the factory settings (factory reset), Tuner – Boss Audio Systems GT-6 User Manual
Page 74: Output select, Global, System, Midi, Manual
74
Factory Settings
Tuner
TUNER Pitch:
A= 440 Hz
TUNER Out:
Bypass
Output Select
Output Select:
COMBO AMP
Global
Low EQ:
0dB
High EQ:
0dB
NS Threshold:
0dB
Reverb Level:
100%
System
LCD Contrast:
16
BANK Extent:
85
Patch Change Mode:
Wait for a Num.
EXP Pdl Hold:
On
Dial Function:
PATCH No.& VALUE
Knob Mode:
Immediate
Pedal Tuner SW:
Off
Amp Switch Mode:
Amp On/Off
Sub CTL1 Func:
Assignable
Sub CTL2 Func:
Assignable
MIDI
MIDI RX Channel:
1
MIDI Omni Mode:
Omni On
MIDI TX Channel:
Rx
MIDI Device ID:
1
MIDI Sync Clock:
Auto
MIDI PC OUT:
On
MIDI EXP OUT:
7
MIDI EXP SW OUT:
81
MIDI CTL OUT:
80
MIDI Sub CTL1OUT:
Off
MIDI Sub CTL2OUT:
Off
MIDI Map Select:
Fix
Manual
1:
PRE (PRE/SP SIM)
2:
OD (OD/DS)
3:
DD (DELAY)
4:
CE (CHORUS)
▲:
FX-1
▼:
FX-2
Restoring the Factory
Settings (Factory Reset)
Restoring the GT-6 to the settings made at the factory is
referred to as “Factory Reset.”
Not only can you return all of the settings to the values in
effect when the GT-6 was shipped from the factory, you can
also specify the range of settings to be reset.
fig.10-301
1. Turn off the power.
2. While holding down PREAMP/SPEAKER On/Off
button and [TYPE VARIATION], turn on the power.
The Factory Reset range setting screen appears in the
display.
fig.10-302
* To cancel Factory Reset, press [EXIT].
3. Press PARAMETER [
] [
] to move the cursor,
and rotate the PATCH/VALUE dial to specify the range
of settings you want to restore to factory settings.
System:
System parameters, Harmonist scales, Auto Riff phrases,
and Preamp, Overdrive/Distortion, and Wah Custom
Edit parameter settings
#1-1–#35-4:
Settings for Patch Number 1-1 through 35-4
4. If you want to proceed with the factory reset, press
[ENTER].
The specified range of data will be returned, and return
to the Play screen.
1
3
3
4
1
2
The range of data you wish to factory reset.