Boss Audio Systems GT-6 - Manual (Page 52)

52
Chapter 5 Settings for Using the Expression and Control Pedals (Pedal Assign)
Active Range
fig.05-15
This sets the operational range within which the value of the
setting changes when an expression pedal or other controller
that changes the value consecutively is used as the source. If
the controller is moved outside the operational range, the
value does not change, it stops at “minimum” or
“maximum.”
(Example)
With Act. Range Lo: 40, Act. Range Hi: 80
fig.05-16a
fig.05-16b
* When using a foot switch or other on/off switching controller
as the source, leave these at “Lo: 0” and “Hi: 127.” With
certain settings, the value may not change.
Controlling Wah and Pitch Bend
with an External Expression Pedal
Make the following settings to control wah and pitch bend
with an expression pedal connected to the SUB EXP PEDAL/
SUB CTL 1,2 jack.
* Set SYS: Sub CTL1 Func (p. 63) to “Assignable.”
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to select from
ASSIGN 1 through 8.
* If the indication in the upper part of the display is flashing,
press [PEDAL ASSIGN] so it stops flashing, and is displayed
normally.
3. Rotate the PATCH/VALUE dial to select the following
settings:
Foot Volume:
P08: SUB EXP FV
Wah:
P09: SUB EXP FW
Pedal Bend:
P10: SUB EXP PS
fig.05-18
4. If Wah or Pitch Bend has been selected in Step 3, carry
out the following.
For Wah:
Press [WAH]; “On” appears in the display.
Next, press PARAMETER [ ] [ ] to display “FX
Select,” then select “FW” with the PATCH/VALUE dial.
For Pitch Bend:
Press [FX-2]; “On” appears in the display.
Next, press PARAMETER [ ] [ ] to display “FX
Select,” then select “PS” with the PATCH/VALUE dial.
0 40 80 127
maximum value
Target Max
minimum value
Target Min
Act. Range
Lo
Act. Range
Hi
OFF
On
Off
Center
value
ON
0 40 80 60 127
Act. Range
Max Act. Range
Lo