Barco CINE7 R9010050 - Manual (Page 91)

9. Service Mode
What can be done?
1. Push the cursor key ↑ or ↓ to highlight Change Language. (menu 9-11)
2. Press ENTER to display the language menu. (menu 9-12)
3. Push the cursor key
↑
or
↓
to highlight the desired language.
4. Press ENTER to change to that language.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with ↑ or ↓
then
to return
Menu 9-11
LANGUAGE
ENGLISH
ESPANOL
FRANCAIS
DEUTSCH
Select with ↑ or ↓
then
to return
Menu 9-12
9.3.6 Change Projector Address
What can be done?
Every projector requires an individual address between O and 255. This address can be set by the software.
How to Change the Projector Address?
1. Push the cursor key
↑
or
↓
to highlight Change Projector Password and press ENTER to select. (menu 9-13)
The current Projector Address will be displayed in the Projector Address menu. (menu 9-14)
2. Push the ← or → keys to highlight the digit to be changed.
3. Press a numeric key to enter the new digit.
4. Repeat step 2 till 3 for the other digits.
5. Press ENTER to save the new password.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with ↑ or ↓
then
to return
Menu 9-13
PROJECTOR ADDRESS
Enter new projector
address:
000
Use ← and → to select,
and reprogram
with numeric keys.
Highest address is 255
to confirm
to return
Menu 9-14
9.3.7 Change Baudrate
What can be done?
The communication speed between projector and computer has 8 possible speeds. The baud rate speed can be software set up.
The following baud rates are available:
• 9600
• 4800
• 2400
• 1200
• 600
• 300
• 150
• 110
R5976584 BARCO CINE7 26022003 87