Barco CINE7 R9010050 - Manual (Page 85)

8. Random Access Adjustment Mode
Image 8-23
Convergence Adjustment
Adjustment order
Adjust first the green only when available and continue with red on green and blue on green.
How to start up Convergence?
1. Push the cursor key
↑
or
↓
to highlight Convergence and press ENTER to select. (menu 8-55)
The Convergence menu will be displayed. (menu 8-56)
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
GEOMETRY
CONVERGENCE
COLOR SELECT
Select with ↑ or ↓
then
to return
Menu 8-55
CONVERGENCE
GREEN ONLY
RED ON GREEN
BLUE ON GREEN
Select with ↑ or ↓
then
to return
Menu 8-56
8.7.2 Convergence Adjustment
Adjustment Order
When green convergence is available, start always with ’green only’ and continue with ’red on green’ and ’blue on green’.
How to perform a Convergence Adjustment?
1. Push the cursor key
↑
or
↓
to highlight the desired adjustment press ENTER to select.
2. Use the cursor keys to select one of the 25 areas and press ENTER to confirm and to toggle the cursor keys to the adjustment
mode. (image 8-24)
Tip:
For the best result, start by adjusting zone 1 and follow the default order as shown in the image.
3. Use the cursor keys to make horizontal or vertical adjustments in the selected zone.
4. Press ENTER to finish convergence adjustment and to toggle the cursor keys to the selection mode.
5. Repeat step 2 till 4 for each area that needs an adjustment.
6. Press EXIT to return to the Convergence.
7. Repeat the same procedure for Red on Green and Blue on Green.
8. Press EXIT to return to the Random Access Adjustment Mode menu.
R5976584 BARCO CINE7 26022003 81