Pioneer AVIC-F840BT - Manual (Page 160)

Setting the rear output
The navigation system
’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
“Rear SP” to
“Sub. W”, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
“Full”).
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p “Rear SP” can be set only when the source
is selected to
“Off”.
p AVIC-F840BT is not compatible with the wir-
ing that the subwoofer is directly con-
nected to rear speaker leads. Always use
the setting with
“Full”.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 158.
2 Touch [Rear SP].
Each touch of [ Rear SP] changes the settings
as follows:
! Full
When no subwoofer is connected to the
rear output, select
“Full”.
! Sub. W
When a subwoofer is connected to the rear
output, select
“Sub. W”.
Switching the preout setting
CAUTION
Ensure the output setting of
“Preout” is the same
as the speaker connected.
p This function is available for AVIC-F840BT
only.
You can switch the output setting of the preout
of this navigation system to the subwoofer or
rear speaker.
p “Preout” can be set only when the source
is selected to
“Off”.
p If you set “Rear SP” to “Sub. W”, you can-
not conduct the setting of
“Preout”.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 158.
2 Touch [Preout].
Each touch of [ Preout] changes the settings
as follows:
! Sub. W (default):
When a subwoofer is connected to the pre-
out outputs (SWL, SWR), select
“Sub. W”.
! Rear
When rear speaker is connected to the pre-
out outputs (SWL, SWR), select
“Rear”.
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal.
p Even if this setting is “Off”, the navigation
system will mute or attenuate the AV
source volume when the mute signal is out-
put via MUTE lead.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 158.
2 Touch [Mute].
Each touch of [ Mute] changes the settings as
follows:
AVIC-F40BT
! Guide/Tel/VR: The volume is muted or atte-
nuated according to the following condi-
tions.
— When the navigation outputs the gui-
dance voice.
Engb
160
Chapter
27 Customising preferences