Pioneer RCS-656HX - Manual (Page 14)

Remote control
14
En
ADVANCED
Use to select a Pioneer original surround mode
(page 24).
SOUND (page 25)
Press to access the sound menu, from which you can
adjust bass and treble, etc.
CLEAR
Press to clear an entry and start again.
23 MENU (page 89)
Press to display the disc menu if a DVD-Video, finalized
DVD-R/-RW or finalized DVD+R/+RW disc is loaded.
When in the GUIDE Plus+™ system, use to jump directly
to the Menu bar.
24 VIDEO IN (page 85)
Press to change the DVD recorder input for recording
and playback.
25 TV/DVD
Press to switch between ‘TV mode’, in which you get the
picture and sound from the TV’s tuner, and ‘DVD mode’,
in which you get picture and sound from the system’s
tuner (or an external input).
26 JUKEBOX (page 116)
Press to display the Jukebox screen of the DVD recorder,
from where you can copy music to the HDD for playback.
27 TV CONTROL (page 140)
After setting up, use these controls to control your TV.
TEXT
Starts the MHEG application display, if available,
while watching a digital channel (UK only).
A.TV/D.TV
Switches between analog TV antenna input and
digital TV antenna input. The
A.TV and D.TV
indicators on the front panel show which is selected.
28 DISPLAY (page 97)
Displays/changes the on-screen information
displays.
RDS DISP
Changes RDS displays (page 27).
29 MAIN/SUB
Change from
MAIN to SUB to access the green
functions/commands on the remote.
Using the remote control
Please keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit’s
remote sensor.
• Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
• When the batteries run down or you change the
batteries, the remote control mode is reset to
Recorder 1. See Remote Control Mode on page 138.
• Use within the operating range in front of the remote
control sensor on the display unit, as shown.
30
30
7 m