AMX UDM-0404 - Manual (Page 74)

Configuration - Protocols Page
62 UDM-0404 4x4 Multi-Format Distribution Hub
Creating and Learning an IR Protocol
IR protocols can be learned by the UDM-0404 by using the device’s remote control to program its
commands into the UDM-0404. This is performed via options in the Protocols page.
The UDM-0404 can learn between 8 and 25 IR commands, depending on the command length and
protocol used.
IR Learning with a Device’s Remote Control
1. In the Protocol page, open the IR protocol drop-down menu, and select New (FIG. 90).
This action invokes two additional fields: Name and Initialise (FIG. 91):
2. Name the IR protocol appropriately, and click on Initialise.
3. Select the action which is to be performed from the Action drop down menu (e.g. vol up - FIG. 92).
4. Click on Step 1 (FIG. 93).
The device’s own remote control can still be used locally at the device to control the
device.
FIG. 90 IR Protocol drop-down menu
FIG. 91 Creating a new IR protocol
FIG. 92 IR protocol - Action drop-down menu
Ensure the device’s remote control is pointing to the IR sensor located at the front of
the UDM-0404 when performing key presses. If not the key presses may not be
stored in the UDM-0404.
FIG. 93 Capturing IR Protocol - Step 1