Default ip address, Serial port, Serial port - default communication settings – AMX UDM-0404 User Manual
Page 19: Db9-to-rj12 adapter cable pinouts

Wiring and Connections
7
UDM-0404 4x4 Multi-Format Distribution Hub
Default IP Address
The default IP address of the UDM-0404 is 192.168.0.96.
Once the UDM-0404 is switched on, use the Setup option in the UDM WebConsole to configure the
correct IP address (see the Configuration - Setup Page section on page 37).
The IP address may also be configured via the serial port (refer to the Backend Commands section on
page 72).
Serial Port
The Serial port on the rear panel (labelled “10101”) is available for diagnostic and troubleshooting
purposes.
The Serial port on the UDM-0404is an RJ12 connector, and requires a DB9-to-RJ12 adapter cable
(FG-RS01) to connect to a PC for Terminal control.
Serial Port - Default Communication Settings
Use hyper terminal with default serial settings to communicate with the UDM-0404 (and UDM-RX01):
DB9-to-RJ12 Adapter Cable Pinouts
The following table provides the pinout configuration for the DB9-to-RJ12 adapter cable:
Connecting the Serial port on the UDM-0404 is not an essential step in the
installation process.
Default Serial Settings
Baud Rate:
9600
Data Bits:
8
Parity:
None
Stop Bits:
1
Flow Control:
None
DB9-to-RJ12 Adapter Cable Pinouts
DB9 connector
Function
Abbreviation
RJ12 connector
Pin 1
Not used
NC
Pin 2
Transmit Data
TD or TX or TXD
Pin 2
Pin 3
Receive Data
RD or RX or RXD Pin 3
Pin 4
Data Set Ready
DSR
Pin 1
Pin 5
Signal Ground
GND
Pin 4, 5
Pin 6
Data Terminal Ready DTR
Pin 6
Pin 7
Not Used
NC
Pin 8
Not Used
NC
Pin 9
Not Used
NC