Xerox WorkCentre PE16-i-4381 - Manual (Page 167)

G ENERAL F AX F UNCTIONS 2.5
2
N OTES :
• For the memory transmission, the super fine mode is not
available. The resolution setting is automatically changed to
Fine.
• When your machine is set to Super Fine resolution and the
remote fax machine does not support the Super Fine resolution,
the machine transmits using the highest resolution mode
supported by the remote fax machine.
Sending a Fax Automatically
1 Load the document(s) face up into the ADF.
OR
Place a single document face down on the document glass.
For details about loading a document, see page 2.2.
2 Adjust the document resolution to suit your fax needs (see
page 2.4).
If you need to change the contrast, see page 1.13.
3 Enter the remote fax phone number using the number
keypad.
You can use one or two-digit speed or group dial numbers.
For details, see Chapter 3, "Automatic Dialling."
4 Press Start Copy/Fax.
5 When the document is loaded on the document glass, the
display shows “Another Page?” on the top line after the
document is scanned into the memory. If you have the next
page, remove the scanned page and load the next page on
the glass and select “1.Yes.” Repeat as necessary.
After all of the pages are scanned, select “2.No” when the
display shows “Another Page?.”
Color(Colour)
Documents with colours. Sending a colour fax
is enabled only if the remote machine
supports colour fax reception and you send
the fax manually. In this mode, the memory
transmission is not available.
Mode Recommended for: