Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-16166 - Manual (Page 35)

Nuvera Stacker/Finisher Script
For the Nuvera family of printers, you must use the following script
to set up Stackers and/or Finishers:
1. Open a terminal window.
2. Login as root.
3. Type cd /opt/XRXnps/bin/DFA_IsStacker.
4. Press .
5. Type ./set –f 0 OR ./set –f 1. Use the value 0 if the
attached DFA device is a finisher, or use the value of 1 if
the attached DFA device is a stacker. Note that there are
spaces before and after the –f switch.
6. Restart DocuSP.
NOTE: This setting is lost on an upgrade or a scrape install
and must be recreated using this procedure.
LPR gateway behavior for document title
Prior to DocuSP 4.0, the controller applied the LPR gateway
filename to submitted documents as opposed to the internally set
document name. Starting with DocuSP 4.0, the controller applies
the internal document name to the job.
To set the DocuSP to the pre-4.0 behavior, run the following script:
1. Open a terminal window.
2. Login as root.
7. Type /opt/XRXnps/bin/enablePre40LPRBehavior True
8. Press .
9. To disable the pre-4.0 LPR behavior, type
/opt/XRXnps/bin/enablePre40LPRBehavior False
10. Press .
11. Restart DocuSP.
NOTE: A document name set in the job ticket has a higher
precedence than the LPR gateway and internal document
attributes.
Getting Started Guide 29