Maximum density auto adjustment, Maximum density auto adjustment -21 – Konica Minolta bizhub PRESS C1070 User Manual
Page 79
5-21
bizhub PRO C1060L
bizhub PRESS C1070/C1070P/C1060
5
Maximum Density Auto Adjustment
Automatically adjust the maximum density of each of yellow, magenta, cyan, and black, using the output paper density
sensor that is installed on the optional Relay Unit RU-509. Carry out this function before carrying out the [Color
Density Control] function.
NOTICE
NOTICE
To enable this function, your service representative must specify the target maximum density value (target density) in
advance. For more information, contact your service representative.
Carry out Maximum Density Auto Adjustment (RU) using the paper that is used to register the target maximum density
value (target density).
When [Maximum Density Auto Adjustment] is performed, image stabilization control is carried out if you return to the
normal screen. After image stabilization control is completed, you must carry out calibration using the image controller.
Then, carry out Color Density Manual Control (page 5-26).
A
Press [Adjustment] on the [MACHINE]
screen.
B
Press [Max.Density Auto Adj. (RU)].
C
Press [Print Mode].