Konica Minolta bizhub PRESS C1070 - Manual (Page 74)

5-16
5.1 Both Sides Adjustment
Zoom ratio adjustment example:
The image on the front side is 10 mm in a
lengthwise direction while the image on the back
side has been lengthened to 10.1 mm.
- Press [Vertical] of [Back], then press [1][0][0].
- Then, press [+/-] to change the mark to set
the adjustment value to [-1.00].
The image on the back side is reduced by 1%.
In this figure, the black mark indicates the
front side and the blue mark indicates the
back side.
Image shift adjustment example:
The image on the back side is misaligned 0.5 mm
downward and 0.3 mm rightward compared with
that on the front side.
- Press [Up/Down] of [Back], then press [5] to
set the adjustment value to [+0.5 mm].
- Next, press [Right/Left], then press [3] and
[+/-] in sequence to set the adjustment value
to [-0.3 mm].
The image on the back side shifts 0.5 mm upward
and 0.3 mm leftward.
F
After the adjustment is completed, press
[OK].
G
Press [Close] to exit the adjustment.
Zoom and Image Shift Adjustment is then
completed.
- To register adjustment values in a paper
profile, press [Register].
- For details about how to register a paper
profile, refer to the HTML User's Guide.
Tips
If printing positions are misaligned between the front and back sides even after the Both Sides Adjustment has been
carried out several times, readjust the reference position on the print side. For details about the adjustment procedure,
refer to the HTML User's Guide.