Konica Minolta NC-503 - Manual (Page 57)

4 Network settings
4-6 NC-503
4.2 Specifying settings from the control panel
The network settings can be specified from the control panel of this machine.
To specify the network settings from the control panel of the machine, press
the [Utility] key, and then specify settings for the various menu parameters
available from the “ADMIN. MANAGEMENT” menu in Utility mode.
Settings can be specified for the following network-related parameters in the
“ADMIN. MANAGEMENT” menu.
*
1
These items can be displayed only IP ADDRESS SETTING is set to “SPEC-
IFY”.
*
2
Can be specified if network interface card NC-503 or image controller IC-
206 is installed on the machine while fax kit FK-506 is not installed.
Menu Submenu Parameter
NETWORK SETTING IP ADDRESS SETTING AUTO / SPECIFY
SUBNET MASK*1 -
GATEWAY*1 -
DNS CONFIG DISABLE / ENABLE
GATEWAY TX DISABLE / ENABLE
WEB SETTING DISABLE / ENABLE
LPD SETTING DISABLE / ENABLE
SLP SETTING DISABLE / ENABLE
SNMP SETTING DISABLE / ENABLE
E-MAIL SETTING 1 SENDER NAME -
E-MAIL ADDRESS -
SMTP SERVER ADDRESS -
SMTP PORT NO. 1 to 65535
SMTP TIMEOUT 30 to 300 seconds
TEXT INSERT OFF / ON
DEFAULT SUBJECT -
POP BEFORE SMTP OFF / ON (0 to 60 seconds)
E-MAIL SETTING 2 POP3 SERVER ADDRESS -
POP3 PORT NO. 1 to 65535
POP3 TIMEOUT 30 to 300 seconds
POP3 ACCOUNT -
POP3 PASSWORD -
USER SETTING NTP SERVER ADDRESS* 2 -
TIME ZONE* 2 -