Konica Minolta bizhub 282 - Manual (Page 132)

Control Panel Settings 5
362/282/222 5-25
Control Panel Settings
Chap
te
r 5
4
Touch either [Bit Selection] or [HEX Selection], and then specify the
setting.
– To specify the bits, touch [Bit Selection], move the cursor to the bit
to be changed, press either the [0] or the [1] key in the keypad to
specify the bit, and then touch [Set].
– To specify the hex value, touch [HEX Selection], specify the value
by either using the keypad or touching [A] through [F], and then
touch [Set].
5
To change the setting for a different mode, repeat steps 3 and 4.
6
Touch [Enter] in each screen until the first screen appears.
7
Turn the machine off with the main power switch, and then wait about
10 seconds before turning it on again.
Soft SW Setting
000
(76543210)
00110000
30 HEX Selection
Mode Selection
Set F
C
E
B
D
A
Bit Selection
Enter
Soft SW Setting
Enter
000
(76543210)
00110000
30
Bit Selection
Mode Selection
Set F
C
E
B
D
A
HEX Selection
362.book 25 ページ ２００８年１０月２０日 月曜日 午前１１時３２分