Software sw settings, Software sw settings -22 – Konica Minolta bizhub 282 User Manual
Page 129
5
Control Panel Settings
5-22
362/282/222
Control Panel Settings
Chap
te
r 5
5.5
Specifying software switch settings (machine func-
tions)
By specifying the software switch settings (“Mode Selection”, “Bit Selection”
and “Hex Selection”), various machine functions can be changed to meet
your specific needs.
2
Reminder
Do not change any modes or bits other than those described in this man-
ual.
2
Note
When “Enhance Security” is set to “ON”, the software switch Settings
cannot be changed.
Software SW settings
Examples of settings for “Bit Selection” (binary numbers) and “HEX Selec-
tion” (hexadecimal numbers) are shown below.
Parameter
Description
Mode Selection
The parameter to be specified is expressed as a three-digit
number. Use the keypad to type in the value.
Bit Selection
The bits are the eight numbers that construct the mode sta-
tus. By specifying a binary number (0 or 1) for each of the bits
(0 through 7), a setting for each parameter can be specified.
HEX Selection
Specify a setting for each mode as a hexadecimal number (0
through 9 and A through F). Bit setting “0011 0000” is ex-
pressed as the hexadecimal setting “30”.
Specify a mode setting by using either bits or hexadecimal
values.
Decimal
number
“Bit Selection” setting (binary
number)
“HEX Selection” setting (hexadeci-
mal number)
0
0000 0000
00
1
0000 0001
01
2
0000 0010
02
3
0000 0011
03
4
0000 0100
04
5
0000 0101
05
6
0000 0110
06
362.book 22 ページ 2008年10月20日 月曜日 午前11時32分