Konica Minolta KIP Color 80 - Manual (Page 36)

KIP Print
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 33 -
CGM (OPTION)
CGM is an option that can be purchased (contact your KIP Sales Represetative)
and then added to the KIP IPS to allow for the printing of CGM files. Once a license is
obtained and added to the KIP IPS (see CGM Manual for instructions) The CGM
columns can be turned on in the KIP PRINT software by going to Options and then
Modify Columns. Check the boxes next to “CGM Width” and “CGM Length” and select
OK.
The Following columns will appear and allow for the printing of CGM files. The
Selection of Auto is default for both columns however specific sizes may also be set
through the dropdown arrows. Please note the CGM format is not viewable in the KIP
Print viewer but will still print when sent to the KIP Printer.
Notes:
-
- KIP software (on the KIP Printer) must be version 7.4.593 or higher.
- KIP Print must be version 7.4.436 or higher.
- The CGM license is based off of the MAC and the IP address of the PC. These
values will be necessary, to obtain the CGM license. To retrieve this please do
the following on the KIP Controller:
1. Close the User Interface on the KIP
2. go to CMD prompt and type in “ipconfig/all”
3. the “physical address” for the active LAN card is the MAC
address and the IPS address will also be noted