Lenovo ThinkServer RD540 - Manual (Page 39)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 21
Current message level: 0x00000000 (0)
Link detected: yes
QLogic Device Windows Property Pages
To access the property pages in Windows:
1. Access the Device Manager as follows:
a. On the Windows desktop, click Start, Control Panel, click Administrative Tools, and then click
Computer Management.
b. In the Computer Management dialog box, click Device Manager.
2. In the left pane of the Device Manager dialog box, right-click QLogic 10Gb Ethernet Adapter, and
then click Properties.
3. On the adapter properties dialog box, click the Advanced tab to bring that page to the front.
4. On the Advanced page, configure the parameters specified in the Table 2.
5. (Optional) Click other tabs to bring those pages to the front and view or change settings, for example:
— Click the Information tab to view the configuration.
— Click the Details tab to view NIC driver details. On the Details page, click items under Property to
view the selected item's value.
— Click the Driver tab to update, rollback, disable, or uninstall the NIC driver.
— Click the Resource tab to view resource settings.
— Click the Statistics tab to view the transmit and receive (general and QLogic-customized) statistics
gathered while the NIC is operational.
6. When you are through viewing and changing driver properties, click OK to close the dialog box, or click
Cancel to revert to the previous driver configuration.
Table 2. Windows Driver Configurable Parameters
Property Description
Completion Queue Size Specifies the size for the ring where command completion and incoming receive
indication status will be posted.
Registry Key: CompletionQueueSize
Default: 16384
Values: 1024, 2048, 4096, 8192, 16384, 32768
Flow Control Sets the hardware flow control parameters.
Registry Key: *FlowControl
Default: Rx and Tx Enabled
Values: Disabled, Rx Enabled, Tx Enabled, Rx and Tx Enabled
Health Monitoring Checks health of firmware, monitors normal operation, and ensures recovery of
the firmware.
Interrupt Moderation Allows interrupt coalescing during receive and transmit operation.
Registry Key: *InterruptModeration
Default: Disabled
Values: Enabled, Disabled